Finish Floor After Removing Toilet

Stuff an old rag in the hole in the floor called the closet flange.

Finish floor after removing toilet.

If that doesn t work you may have to cut the bolts with a hacksaw or split the nuts with a nut splitter. After a new wax ring is in place on the floor flange you should have completely scraped away the old one with a putty knife position the pick up stix beneath the rim of the new toilet bowl. Try spraying the toilet bolt nuts with penetrating oil if they won t budge. Next move your caulk gun to the inset depth you just measured and apply caulk directly to the floor maintaining the inset depth as you follow the tape.

Underneath there are the bolts that are holding the toilet to the floor. Find the old wax ring that sticks the base of the toilet to the floor and remove it. If you re removing the entire toilet and not just removing the back tank to paint behind the toilet you ll need to remove the bolt caps. Most toilets are held to the floor by two bolts one on each side of the flange at the bottom of the toilet.

Cutting flooring around these obstacles is difficult even for the. You should then be able to lift the toilet off the floor leaving only the drain opening. Removing the toilet before floor replacement can be quite difficult. How to remove rusty toilet bolts.

This procedure doesn t require much accuracy however. Toilet bases are often oddly shaped with many curves and rounded corners. Rest the toilet on an old blanket or newspapers. Just use a flathead screwdriver to pop them off.

Pry off the trim caps on the floor bolts if necessary and then remove the nuts from the floor bolts with an adjustable wrench. This hole is a direct path to the soil pipe that leads to the sewer or septic system. After removing a pedestal you should be able to lay the floor without any extra cutting but you ll have to cut around a toilet flange. Against a toilet however there is no new sheet to form a seam and nothing to cover an expansion gap leaving an obvious channel in the floor around the toilet.

Measure the depth and width of the gluing edge of the bowl. References this old house. Remove the toilet and turn it on its side. Cut through the putty that holds the toilet to the floor using a sharp utility knife.