Flat Bar To Reattach Siding

Vinyl siding is hung loosely to allow it to expand and contract in the sun.

Flat bar to reattach siding.

Use flat bar to carefully pry up the siding course above. Insert the hook of a vinyl siding removal tool into the buttlock of a panel you want to snap back in place. Remove the damaged panel s nails with a pry bar. After that slide your flat bar behind the vinyl siding.

Use a pry bar to remove fastening nails little by little as you work towards the opposite end of the panel. You can do this with a small pry bar or by hand. With vinyl siding the nails are hidden by the row above and it is difficult to get to them. You ll want to work your way up and down the piece and keep pressure on the bottom of the piece above.

The tool is available at most hardware stores and usually costs less than 10. Use the flat bar to pry up the siding and remove the nails. Only bend panels enough to gain access to the nails fastening the damaged panel to the side of your house. I might as well once it s cut you ll simply begin prying away the broken piece.

To remove the old siding simply score or cut away any old caulk or paint that might be in the joints. When the siding is unzipped bend it up out of the way using your elbow. If it is sagging or has come loose from the outside of your house you canmot just drive a few nails through the siding to reattach it. Find metal siding trim at lowe s today.

Now the top piece is free and you can remove the nails holding the center piece in place. If the fc lap siding boards are nailed very tightly you may be able to reach up under the board you are going to remove using a flat bar to pry gently at the top of the board beneath thus the board to be removed and the lower edge of the board course above it prying thus between the back of the lower board and the wall sheathing just enough to open the boards enough to go back to the hacksaw. Drive flat bar into nails to bend them then tap siding to wall causing the nail heads to pop. Continue to slide the zip tool along the edge until the entire piece is freed.